Vehicle Wrap Removal & Installation

What happens when the perfect design becomes obsolete and needs replaced? How can I save myself money and how do I remove a wrap without damaging the paint on my vehicle?

A clean vehicle wrap removal begins before the vehicle wrap is ever installed. The surface must be cleaned properly with isopropyl alcohol before the vinyl fleet graphics are applied. Cleaning the surface helps the adhesive bond and ultimately remove properly. The surface and condition of the vehicle are also very important in vehicle wrap removal. Vehicles with rust, or other defects may not be warranted or the condition of the vehicle may be deemed unwrappable. Another tip is to properly care for your vehicle during the life of the wrap, regular cleaning and sealing will help the longevity of the wrap. Parking in a garage is recommended to help increase the life of the wrap as well.

When removing the vehicle wrap, make sure the optimal surface temperature of the vehicle graphic is achieved. Various materials have different temperature ranges so its best to check with a VMS sales representative or the material manufacturer. Don’t remove a vehicle wrap in direct sunlight, in too cold of weather, or other conditions that may adversely affect the removal process.

vehicle wraps roi

Start by peeling a corner or edge of the material and slowly peel the graphic away. Make sure when pulling the vinyl that you maintain less than 90* angle so that the vinyl doesn’t tear or break apart. If the decal becomes difficult to pull, stop, and heat the vinyl using a heat gun or propane torch and resume. Be sure to keep consistent pressure, angle and speed while you remove the graphic.

Adhesive residue may be left behind after the vinyl is removed. There are several manufactured products that help remove the adhesive from the vehicle without damaging the surface. After removing an old wrap be sure to remove all residual adhesive, because vinyl can be applied to numerous surfaces such as glass, PVC, aluminum, vehicles, trailers, drywall, or concrete be sure to use products that are recommended for the unfamiliar substrate or contact a VMS PDAA Certified Installer.

After you have successfully removed the graphic its time to get started on your next design. Contact VMS with any questions about how to remove a wrap, or how to get started on your next vehicle wrap or decal project.

request a quote